Running two amp f2s bridged from my A8, if the XLR cables are within 2 inch of any power cable I get a load crack on boot up and shut down. If this happens the amps do not have audio until they are manually turned off and back on again, positioning XLR cables out of the way gets rid of this problem, but my question is, should the interference cause such a bad effect? Literally causing such a loud crack and putting the amps into what appears to be some sort of protection mode? I'm using...
DMP A8 on eversolo amp f2 ( XLR interference )
DMP A8 on eversolo amp f2 ( XLR interference )